P.O.I® 34 mm Picatinny Scope Rings | UTG PRO®

• Proudly Designed and Made in USA

• High Profile P.O.I Rings Have a 01.46 in or 37 mm Center Height to Fit Optics with a 34 mm Tube, for up to a 73 mm Outer Objective
• Medium Profile P.O.I Rings Have a 1.26 in or 32 mm Center Height to Fit Optics with a 34 mm Tube, for up to a 63 mm Outer Objective

• Patented P.O.I Locking Plate and Precision Optics Interface Design Features:

a) Flush-Fitting Low Profile Steel Locking Side Plate Controlled by Dual Spring-Loaded Guide Rods for Easy Installation

b) Square-Shaped Integral Recoil Stop for Complete Surface Contact with Picatinny Slot and Secure and Repeatable Zero Hold

c) Top and Bottom Rings Precision-Machined from 1 Piece of Al for Tight Tolerance Inner Diameter and Seamless Ring-to-Scope Interaction

• 2 Piece Ring Set with 22 mm Ring Width, Torx-Locking and Equipped with 4 Top Torx Screws
• Designed to Fit on Mil-spec 1913 Picatinny Rail Platforms
• Machined from 6061-T6 Aluminum with Steel Construction and Matte Black Hardcoat Anodize
• Rated for .50 BMG
• NOTE: We recommend to tighten the ring top screws with a torque value of 25 inch-lb and the side plate screw with torque value of 45 inch-lb.